REHM BARRACUDA RTC 60 - Machine Configuration RTC 100; RTC 150; Standard Accessories RTC 100; RTC 150; Plasma Torches R145 and R145 P

Accessories
23
4.3.2 Machine configuration RTC 100 / RTC 150
4.3.2.1 Standard accessories RTC 100 / RTC 150
Description
Order no.
RTC 100
Order no.
RTC 150
Earthing clamp with terminal
360 0004
360 0111
Mains cable with connector
360 0134
360 0135
Plasma torch A80
766 1456
766 1456
Set of wear parts
750 0728
750 0729
Set of operating and functional
instructions
730 0275
730 0275
4.3.2.2 Plasma torches R145 and R145P
Torch: Plasma torch R145 (order no. 766 1456)
Plasma torch R145 automatic torch (order no. 766 1466)
Mono-gas plasma torch 6 m with central connector and safety switch
Technical Data
(Technical data for R145P is the same as for torch type R145)
Maximum cutting current: 150A
Duty cycle at I
max
: 100%
Air pressure: 5-5.5 bar
Air flow rate: 230 l/min
Nozzle diameter: 1.4mm for current range 40-60A
1.6mm for current range 70-120A
1.8mm for current range 110-150A
3.0mm for gouging
Set of wear parts: Nozzle diameter 1.4 mm
(RTC 100 / RTC 150)
1 nozzle diameter 1.6mm
(RTC 100 / RTC 150)
1 nozzle diameter 1.8mm (RTC 150)
2 electrodes (RTC 100)
3 electrodes (RTC 150)