5 Commissioning
5.1 Safety instructions
Please read the operating instructions carefully, especially
Chapter 2, Safety
Instructions, prior to commissioning of the equipment and before you begin
working on this cutting current source.
Warning!
REHM plasma cutting equipment may only be operated by personnel
trained and instructed in the use, maintenance and safety provisions of
plasma cutting equipment.
Always wear protective clothing during cutting and ensure that other
people who are in the vicinity are not endangered by UV radiation from the
arc.
5.2 Working under increased electrical danger in
accordance with the provisions of IEC 974, EN
60974-1 and VBG 15 (S)
REHM plasma cutting equipment complies with the above regulations.
Care should be taken that the cutting current source is not set up in this area
when working under increased electrical danger. Please observe regulations EN
60974-1 and VBG 15.
5.3 Transport and set-up of the plasma cutting
equipment
Set up the REHM plasma cutting equipment so that the user has sufficient room
in front of the equipment to monitor and operate the controls.
Set up the REHM plasma cutting equipment so that there are no obstructions of
the air intake and outlet. The stated duty cycle of the equipment can only be
achieved if there is adequate air throughput.
When transporting the unit, always comply with the applicable accident prevention
regulations. When transporting the unit with a crane, use the lifting rings attached
to the housing.
Danger! Electric voltage
Do not use the plasma cutting equipment in the open air when it is raining!
To Next Page