7 Faults
7.1 Safety instructions
Warning!
In the event of a fault which constitutes a danger to persons, equipment
and/or the surroundings, switch off the equipment immediately and ensure
that it cannot be switched back on.
Do not resume operation of the equipment until the cause of the
malfunction has been eliminated and there is no longer any hazard to
persons, equipment and/or the environment.
Faults should be rectified only by qualified staff observing all safety
instructions.
Chapter 2.
The equipment must be inspected and approved by qualified staff before it
is used again
Troubleshooting Table.
If the equipment is properly set up and handled, plasma cutting using the REHM
BARRACUDA cutting equipment will become a simple, reliable separation
process. If nevertheless any faults should occur, we would like to give you the
following practical advice and tips on how to eliminate them. If you are unable to
solve the problem using this information, we would ask you to contact your
supplier, who will be happy to help you further.
General information:
Different metals, especially non-ferrous metals, have quite different heat
conduction properties, which have an effect on the appearance of the cut
surface/cutting results. In such cases, you should check whether alteration of the
current setting, the nozzle, the distance from the work piece or the speed at which
the torch is moved could produce better results.
To Next Page