4.3 Torches and accessories 21
4.3.1 RTC 60 machine configuration 21
4.3.1.1 Standard accessories for RTC 60 21
4.3.1.2 Plasma torches A80 and P80 Aut 22
4.3.2 Machine configuration RTC 100 / RTC 150 23
4.3.2.1 Standard accessories RTC 100 / RTC 150 23
4.3.2.2 Plasma torches R145 and R145P 23
4.3.2.3 Accessories for torch R145 25
4.3.3 Circle cutting equipment and magnet clamps 26
5 Commissioning 27
5.1 Safety instructions 27
5.2 Working under increased electrical danger in accordance with the provisions
of IEC 974, EN 60974-1 and VBG 15 (S) 27
5.3 Transport and set-up of the plasma cutting equipment 27
5.4 Connection of the plasma cutting equipment 28
5.5 Cooling of the plasma cutting equipment 28
5.6 Compressed air supply 28
5.7 Guidelines for working with cutting current sources 28
5.8 Connection of workpiece return cables/torch 29
5.9 Recommended cross-sections of welding power supply cables 29
5.10 Connection to jigs 29
6 Operation 30
6.1 Safety instructions 30
6.2 Electrical Hazards 30
6.3 Information for your personal safety 31
6.4 Fire Protection 31
6.5 Ventilation 32
6.6 Checks before switching on 32
6.7 Connection of the earthing cable 33
7 Faults 34
7.1 Safety instructions 34
7.2 Troubleshooting Table 35
8 Maintenance Work 38
8.1 Safety instructions 38
8.2 Maintenance table 38
8.3 Cleaning of equipment interior 39
8.4 Proper waste disposal 39
9 Circuit diagrams 40
10 List of Components 43
10.1 Sparepart list REHM RTC 43
11 Mechanised interlocks 48
11.1 RTC units with 7-pin interface (only for RTC 100 and RTC 150) 48
11.2 RTC units with 17-pin interface (only for RTC 100 and RTC 150) 48
11.3 Connection schematic for 7-Pole mechanised cutting interface 49
11.4 Connection schematic for A-pole mechanised cutting interface 50
12 Technical Data 51
13 Index 52
To Next Page
Loading...
