Renault MASTER 2024 - Page 131

TRIP COMPUTER
2
Getting to know your vehicle - 129
Vehicle fitted with trip computer B
The functions are distributed in zones
5 and 6 .
Press switch 1 to navigate between
zones and select the functions by
pressing switches 2 or 3 (the display
depends on the vehicle equipment and
country):
a) Triplog,operatingfaultsandinfor
mation message readout;
b) journey settings:
– average energy consumption;
– current energy consumption;
– estimatedrangewithremainingen
ergy;
– mileage;
– average speed;
c) trip mileage recorder and average
speed;
d) reset the tyre pressure;
e) setting the time;
f) service interval.
Resetting the trip mileage recorder
andjourneyparameters(resetbut
ton)
(depending on the vehicle)
With one of the trip settings selected
as the display, press and hold switch 4
"OK" until the display resets to zero.
Automatic resetting of the journey
parameters
Resetting occurs automatically when
themaximumvalueofanyofthepara
meters is exceeded.
Interpreting some of the values
displayed after resetting
The greater the distance travelled
since the last reset, the greater the
stability and reliability of the average
energy consumption, range and speed
values.
For the first few miles after pressing
the reset key you will notice that the
range increases as you travel.
Thisrangetakesintoaccounttheaver
age fuel consumption since the last
time the reset button was pressed.
However,theaverageenergycon
sumption may fall when:
– the vehicle stops accelerating;
– the engine reaches its operating
temperature (if the engine was cold
when the reset key was pressed);
– whendrivingfromanurbanareaon
to the open road.
Resetting the estimated range
After the traction battery has been fully
recharged, you can select two types of
resetting: manual or automatic.