LIGHTING AND SIGNALS
2
160 - Getting to know your vehicle
Exterior lighting and signals
Controls
Daytime running lights
The daytime running lights come on
automatically (without any action on
the stalk
1
) when the engine is started
and they switch off when the engine is
switched off.
Side lights
Turn the ring
3
until the symbol
is opposite the mark
2
. This indicator
light on the instrument panel comes
on.
Note: depending on the vehicle, the
sidelightscanonlybeactivatedmanu
ally when the parking brake is applied
or, depending on the vehicle, when the
gear lever is in the Pposition.Other
wise, the "Unavailable position lights"
messageisdisplayedontheinstru
ment panel to inform you that it is not
possible to activate the side lights.
Dipped beam headlights
Manual operation
Rotate the ring
3
until the symbol is
aligned with the mark
2
. The
warninglightisdisplayedonthein
strument panel.
Before driving at night,
check that the electrical
equipment is operating
correctly and adjust the
headlight beams (if your vehicle is
not carrying its normal load). As a
general precaution, check that the
lights are not obscured (by dirt,
mud,snoworobjectsbeingtrans
ported).
Operating faults
When the "Check Automatic Lighting"
message appears on the instrument
panel,thesystemisdeactivated.Con
sult an approved dealer.