LIGHTING AND SIGNALS
2
Getting to know your vehicle - 161
Additional cornering lighting
(depending on the vehicle)
In forward gear, if the dipped beam or
mainbeamheadlightsareonandde
pending on the steering wheel angle,
this function adapts the beam width to
improve visibility on a bend or at a
junction.
Main beam headlights
With the engine running and the
dipped beam headlights on, push the
stalk
1
(movement
A
).
The warning light appears on
the instrument panel.
Toreturntothedippedbeamhead
lights position, push the stalk
1
again.
Automatic main beam headlights
Depending on the vehicle, this
systemswitchesthemainbeamhead
lights on and off automatically.
Itusesacameralocatedbehindthein
teriorrearviewmirrortodetectvehi
cles that are being followed and those
coming in the opposite direction.
Note: at night, in urban areas with
street lighting, the automatic main
beam headlights automatically switch
off.
The main beam headlights come on
automatically if:
– the exterior light level is low;
– noothervehicleorlightingisdetect
ed;
– thevehiclespeedisaboveapproxi
mately 25 mph (40 km/h).
If any of the above conditions are not
fulfilled, the system switches to dipped
beam headlights.
Note: make sure that the windscreen
isnotobscured(dirt,mud,snow,con
densation, etc.).
Activation/deactivation
To activate the automatic main
beam headlights:
Rotate the ring
3
until the "AUTO"
symbol is aligned with the mark
2
,
then press the switch
6
.
The indicator light ontheinstru
ment panel lights up if the dipped
beam headlights are on.
To deactivate the automatic main
beam headlights:
Press the switch
6
: the warning
light disappears from the instrument
panel.
Note: when you push the stalk
1
, the
automaticmainbeamheadlightsfunc
tion is deactivated, the warning
light disappears from the instrument
panel and the vehicle activates the
main beam headlights.
Operating faults
Ifthe"Checkautomaticlighting"mes
sage appears on the instrument panel,
the system is deactivated.
Consult an approved dealer.