Renault MASTER 2024 - Tyre Pressure Loss Warning; Operating Principle

TYRE PRESSURE LOSS WARNING
3
208 - Driving
Ifthevehicleisequippedwiththefunc
tion, this system monitors the tyre
pressure.
Operating principle
Each wheel (except for the emergency
sparewheel)hasasensorintheinfla
tion valve which periodically measures
the tyre pressure.
Thesystemalertsthedriverofanysta
tuses/malfunctionsbydisplayingmes
sages on the instrument panel 🡺211.
Resetting the standard level for
the tyre pressures
It should be done when the standard
tyre pressure needs to be changed to
adapttousageconditions(empty,car
rying a load, motorway driving, etc.).
Itshouldalwaysbedoneaftercheck
ing the tyre pressure when cold.
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving,
etc.).
In the event of a wheel
change or swap, a reset
and pairing of the pressure
sensoridentifiersmustbeper
formed, contact an approved
dealer.
Resetting procedure from the
instrument panel 1
Ignition on, vehicle stopped:
– tapswitch 2 asmanytimesasnec
essary to reach the "Vehicle" tab;
– tapswitch 3 or 4 repeatedly to
reach the "Tyre Pressure" page;
– press and hold (around 3 seconds)
control 5 tostartthereset.The"Learn
ing Tyre Pressures" message confirms
thattheresetrequestforthetyrepres
sure reference value has been taken
into account.
Resetcantakeseveralminutesofdri
ving.
Note:thetyrepressurereferenceval
uecannotbelessthanthatrecom
mended and indicated on the door
frame.
For your own safety, the
warning light
requiresyoutostopim
mediately,assoonastrafficcon
ditions allow.