Renault MASTER 2024 - Page 192

GEAR CONTROL
3
190 - Driving
Note: with the engine running and the
vehiclemovingatbetweenapproxi
mately 0 and 5 mph (8 km/h) in N or D
position, you must press the brake
pedal in order to engage R position.
Parking the vehicle
P position is automatically engaged on
equipped vehicles when:
– the engine is stopped;
– the driver's seatbelt is unfastened
and the vehicle is stationary;
and
– the driver's door is opened and the
vehicle is stationary.
P is displayed on the instrument panel.
As P position is automatically en
gaged when the engine is stopped, it
is sometimes necessary to engage N
positionwhenvisitingcertainloca
tions, for example a car wash:
– with the engine running, press the P
button, shift the selector lever A or B
a notch upwards or downwards to shift
to N position, then stop the engine;
– withtheenginestoppedandtheigni
tion on, shift the selector lever A or B
a notch upwards or downwards then
switch off the ignition.
The next time the engine is restarted,
P position is engaged automatically
accordingtothecasesdescribedearli
er.
For safety reasons, do
not switch off the ignition
before the vehicle has
come to a complete
standstill.
Operating faults
In the event of an engine fault or an
electrical fault (battery fault, etc.),
make sure that the vehicle is properly
immobilised.
Animpacttotheunder
side of the vehicle while
manoeuvring(e.g.strik
ing a post, raised kerb or
other street furniture) may result
indamagetothevehicle(e.g.de
formation of an axle).
To avoid any risk of accident,
have your vehicle checked by an
approved dealer.
Gearstick
Selecting reverse gear
With the vehicle stationary, move the
gearleverintoneutralthenintore
verse.
Observing the grid on the lever knob
1 , lift the ring 2 towards the knob in
order to engage reverse gear.
The reversing lights will come on as
soon as reverse gear is selected (with
the ignition on).