ADDITIONAL DRIVING AID FUNCTIONS
3
Driving - 221
– "High";
– "Lane departure anticipation": adjust
the line detection sensitivity level. To
do this select:
– "Late": line detected when
crossed;
– "Standard": line detected when
approached;
– "Early": line detected when near.
Adjusting settings from the trip
computer
4
– With the vehicle stationary, press
theswitch
5
asmanytimesasre
quiredtoreachthe tabor,de
pending on the vehicle, the tab;
or
– depending on the vehicle, press
switch
5
and repeatedly press control
6
or
7
to reach the menu. Press
switch
8
OK;
– repeatedly press control
6
or
7
to
reach the " " menu or, depending
on the vehicle, the " " menu.
Press switch
8
OK;
– repeatedlypresscontrol
6
or
7
to
reach the "DRIVING ASSIST" menu.
Pressswitch
8
OK.
To adjust the sensitivity:
– repeatedlypresscontrol
6
or
7
to
reach the "Lane departure warning
sensitivity" menu. Press switch
8
OK;
– presscontrol
6
or
7
repeatedly to
adjustthesetting.Pressswitch
8
OK.
To adjust the vibration intensity:
– repeatedlypresscontrol
6
or
7
to
reach the "Lane departure vibration"
menu. Press switch
8
OK;
– presscontrol
6
or
7
repeatedly to
adjustthesetting.Pressswitch
8
OK.
Function temporarily unavailable/
disabled
The function is temporarily unavailable
or disabled in the following cases:
– very fast lane departure;
– driving continuously on a line;
– approximately four seconds after
changing lanes;
– tight bends;
– impaired visibility;
– oneofthedirectionindicatorsisacti
vated;
– activating the hazard warning lights;
– engaging reverse gear;
– strong acceleration;
– the lane width changes;
– operation of the Electronic Stability
Control system;
– operation of the anti-lock braking
system;
– theactiveemergencybrakingsys
tem is triggered;
When the function is not available, the
warning light or, depending on
the vehicle, the left-hand and right-
hand lines
9
and the warning
light appear in grey on the instrument
panel.
When the front camera is obscured,
the"Frontcameranovisibility"mes
sage appears on the instrument panel.
Clean the area where the sensors are
located.
Operating faults
When the system detects an operating
fault, depending on the vehicle:
To Next Page
Loading...
