Renault MASTER 2024 - Page 346

TYRES
6
344 - Practical advice
With the wheel on the ground, tighten
the bolts with force, starting with side
C , then E , G , D and end with F .
Check the tightness and tyre pressure
on the emergency spare wheel as
soon as possible.
If you have a puncture,
replace the wheel as
soon as possible.
A tyre which has been
puncturedshouldalwaysbein
spected (and repaired, where
possible) by a specialist.
Wheeltrims,wheeltrim–wheel
Trim 2
(concealed wheel bolts)
Remove it using hubcap tool 1 by
pushingthehookintotheopeninglo
catednearthevalve(toreachthemet
al retaining wire located behind the
wheel trim).
To refit it, align it with the valve. Push
the retaining hooks in fully, starting on
the side of valve A , followed by B and
C , ending with the side opposite valve
D .
Central wheel trim 4
(concealed wheel bolts)
Remove it using the hubcap tool 1 ,in
serting the tool into the recesses 3
provided.
To refit it, align it with the wheel bolts,
clip it in and check it is securely
locked.