Renault MASTER 2024 - Page 352

BREAKDOWN RECOVERY
6
350 - Practical advice
battery supplying the current should
have a capacity (amp-hours, Ah) which
isatleastthesameasthatofthedis
charged battery.
Ensure that there is no risk of contact
between the two vehicles (risk of short
circuiting when the positive terminals
are connected). Switch off your vehicle
ignition.
Attachthepositivecable(+) A to the
terminal 3 after opening the cover 5 ,
thentoterminal(+) 2 of the battery
supplying the current.
Attachthenegativecable(˗) B toter
minal(˗) 1 of the battery supplying the
current,thentoearth(˗) 4 .
Starttheengineofthevehiclesupply
ingthecurrentandrunitataninterme
diate engine speed.
If your vehicle's engine does not start
immediately, switch off the ignition and
wait a few seconds before repeating
the operation.
With the engine running, disconnect
cables A and B in the reverse order
(4  1  2  3).
Ensure that there is no
contact between cables
A and B andthatposi
tive cable A is not in
contactwithanymetalliccompo
nent in the vehicle supplying the
current.
Risk of injury and/or damage to
the vehicle.