EasyManua.ls Logo

Renault TRAFIC 2024 - Page 264

Renault TRAFIC 2024
408 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ADAPTIVE CRUISE CONTROL
3
262 - Driving
Overtaking manoeuvre
If you wish to overtake the vehicle in
front,activatingtheindicatorwilltem
porarilycancelthesafedistancecon
trol and enable an acceleration speed
sufficient to complete overtaking.
Putting the function on standby
Putting the adaptive
cruise control on standby
or switching it off does
notcausearapidreduc
tion in speed: you must brake by
pressingthebrakepedalifneces
sary.
You can set the function to standby
when:
you press switch
3
(0);
you apply the brake pedal while the
vehicle is moving.
Thefunctionisdeactivatedbythesys
tem if:
you unbuckle the driver's seat belt;
youopenoneoftheopeningele
ments;
youpresstheenginestart/stopbut
ton;
the slope is too steep;
the vehicle speed is above 105 mph
(170 km/h);
certain driving aids and correction
devicesaretriggered(activeemer
gency braking, ABS, ESC, etc.);
when you press the clutch pedal for
a prolonged period or upon prolonged
neutral position on vehicles equipped
with a manual gearbox.
If it goes on standby, this is confirmed
when the warning lights appear in grey
andthe"AdaptiveCruiseControldis
connected" message appears on the
instrument panel.
Exit from standby
Based on the stored cruising
speed
If a speed is stored, it can be recalled,
onceyouaresurethattheroadcondi
tions are suitable (traffic, road surface,
weather conditions, etc.).
Press switch
6
(RES/+) within the valid
speed range.
Whenthestoredspeedisrecalled,ac
tivationofthecruisecontroliscon
firmedbytheilluminationofthecruis
ing speed in green.
Note: if the stored speed is higher
than the current speed, the vehicle will
accelerate to reach that speed.
Based on the current speed
Whenthecruisecontrolissettostand
by, pressing switch
5
(SET/)reacti
vatesthecruisecontrolfunctionwith
out taking into account the stored
speed:itisthespeedatwhichtheve
hicleismovingthatistakenintoac
count.
"Takecontrolofthevehicle"warn
ings
In some situations (e.g. coming up
on a much slower vehicle, vehicle in
front changing lanes quickly, etc.)
the system may not have time to re
act.
Depending on the situation, the system
sounds a beep associated with:

Table of Contents

Related product manuals