TYRES
6
Practical advice - 347
Remove the wheel trim 🡺0.
Unlock the wheel bolts using the wheel
brace
1
. Position it so as to be able to
push from above.
Anti-theft bolt
If you use anti-theft bolts, fit
these nearest the valve
(otherwise it may not be possi
ble to fit the wheel trim).
Position the jack
2
horizontally, with
the head pin
3
aligned with the hole
4
in the lower part of the bodywork near
est the wheel concerned.
Begin to crank the jack so that the
baseplate is correctly positioned (it
should be underneath the vehicle and
aligned with the jack head).
Loosen the wheel nuts and remove the
wheel.
Fit the emergency spare wheel in
place on the centre hub.
Tighten the nuts and lower the jack.
With the wheels on the ground, tighten
the nuts fully and check if they are tight
as quickly as possible.
Position the trim.
To Next Page
Loading...
