TYRES
6
348 - Practical advice
For your safety, the use
ofajacknotrecom
mendedbythemanufac
turer is strictly prohibited.
The jack is specific to the vehicle
and used to change the wheels.
Under no circumstances should it
be used:
– on another vehicle;
– to carry out a repair;
– to access the underside of the
vehicle.
Risk of injury.
Risk of damage to the vehicle.
Wheel trim, wheel
Do not leave the tools
unsecuredinsidetheve
hicle as they may be
projected during brak
ing. After use, check that all the
tools are correctly clipped into
their casings, then position them
correctlyintheirhousingstore
duce the risk of injury.
Trim
1
Remove it by using the hubcap tool
2
(located in the tool kit) to fit the hook
into one of the openings around the
edge of the wheel trim.
To refit it, align it with the valve
3
.
Pushtheretaininghooksinfully,start
ing on the side of valve
A
, followed by
B
and
C
, finishing at the side opposite
valve
D
.
Trim
4
Remove it using the hubcap tool
2
(lo
cated in the tool kit) by engaging the
hook in the opening near the edge of
the trim.
Torefit,positionthefivetrimattach
mentsfacingthefivewheelattach
ments and press hard in the middle of
the trim to clip it to the wheel.