Renkforce RF100 v2 - Page 11

11
• Completelyunwindthepowercablebeforeuse.Apowercablethatisnotcompletelyunwoundcanlead
tooverheatingandconstitutesarehazard!
• Themainsoutletmustbelocatedneartothedeviceandbeeasilyaccessible.
• Neverunplugthemainsplugfromthesocketbypullingonthecable.Alwaysusethegripsonthesides
oftheplug.
• Unplugthemainsplugfromthemainssocketifyoudonotintendtousethe3Dprinterforaprolonged
period of time.
• Forsafetyreasons,unplugthemainsplugfromthemainssocketduringthunderstorms.
• Unplugthemainsplugfromthemainssocketafteruse.
• Alwaysunplugtheproductwhenitisunattended.
• Unplugtheproductfromthemainsandcomputerbeforemaintenanceworkormodicationandletit
cool down.
• Makesurethatthepowercableisnotsqueezed,bent,damagedbysharpedgesorputundermechanical
stress.Avoidexcessivethermalstressonthepowercablefromextremeheatorcold.Donotmodifythe
powercable.Otherwisethepowercablemaybedamaged.Adamagedpowercablecancauseadeadly
electricshock.
• Donottouchthepowercableifitisdamaged.First,powerdowntherespectivemainssocket(e.g.via
therespectivecircuitbreaker)andthencarefullypullthemainsplugfromthemainssocket.Neveruse
theproductifthepowercableisdamaged.