Renkforce RF100 v2 - SD Card Content; SD Card 3 D Models; SD Card Configuration Files

6
5. SD card content
• TheSDcardcontainsthefollowingmainfolders:
- 3D Models
- Cong
- Manual
- Software
ToviewthecompleteSDcardcontent,connectthe3DprinterwiththeinsertedSDcardtoyourcomputer.
Viathecontrolpanel,youwillhavelimitedaccesstotheSDcard.
a) 3D Models
• The folder “3D Models“ contains several subfolders with “Basic shape“, “Capital letters (A-Z), “Constellation“,
“Mathematicalsymbols“,“Numbers“,“VariousObjects“etc.
• Thereareover100ready-to-print3Dmodelsavailable.
• Eachmodelisavailablein.gcode,.jpg,.stlformat.Forexample“RF100“:
• JPGisapreviewofthemodel.
WithSTLyoucancreateyourownGCODEbyusing“Cura“software.
UseGCODEforprinting.
• InserttheSDcardintotheSDcardslotorreadthe.stlleinto“Cura“togetreadyforprinting.
Onthecontrolpanelonlythe.gcodelesarelisted.
b) Cong
• Thefolder“Cong“containscongurationlesfordifferentlamentmaterials:
- “Copper“
- “Elastic“
- “PLA“
- “Wood“
• Loadthecongurationleto“Cura“forprintinganobjectwithchosenlamentmaterial(fordetails,referto“f)Load
congurationle–Windows
®
”onpage38).
The content of this folder cannot be reviewed on the control panel. These conguration les are
recommendedforthesuppliedlaments.Youcanalsocreateyourowncongurationsettingsbyusing
“Cura“ software.