Renkforce RF100 v2 - Printing from SD Card; Starting a Print from SD Card

25
15. Print from SD card
Whenheating,theremaybeslightdevelopmentofsmokeorsteam.Thisisnormal.Pleaseensurethe
correspondingventilation.
Donotapplyanymechanicalforceonthebuildbed.Dangerofbuildbedbreakage.
• PrintingdirectlyfromtheSDcardcanbeperformedonlyviathecontrolpanel.Itdoesnotrequireinstallationofthe
software.The3DprintermustbedisconnectedfromthePC.Ifconnected,pleaseunplugtheUSBcable.
a) Start printing
Info screen
Prepare
Print from SD
1
Software
Manual
Config
3D Model
2
Main
RF100.gcode
3
• Pressthecontrolknobandselect
< Print from SD > in < Main >
menu.
• Navigateinthemenuandselect
< 3D Model >.
• Select a printable model for
example<RF100.gcode>.
• Please note that only les in
.gcode format is shown in the
menu.
4
5
• The<Infoscreen>appearson
theLCdisplay.
• The build bed moves to zero
along the Z-axis. The nozzle
movestothehomepositionand
startsheating.
• When the nozzle reaches the
target temperature, the printing
starts.
• After printing is done, let the
printed object cool down for a few
minutes.
• Takeoutthe buildbed.Remove
the printed object carefully with
thescraper.
• Calibratethebuildbedagain.