Renkforce RF100 v2 - Product Disposal

46
Problem Possible Solution
"Tempsensorerror"isshownonthedisplay,
controlknobiswithoutanyfunctionand3Dprinter
does not work.
Switchoffthe3Dprinter.Removeprotectivecaseofthe
extruderunitandcheckwhetherallcablesareconnected
correctly.
Thermistor and heater are malfunctioning and cannot
detect the extruder temperature correctly Replace the
thermistorwithheater(availableunderitemno.1538778).
19. Disposal
Electronicdevicesarerecyclablewasteandmustnotbedisposedofinthehouseholdwaste.Attheendof
itsservicelife,disposeoftheproductaccordingtotherelevantstatutoryregulations.
Youthusfullyourstatutoryobligationsandcontributetotheprotectionoftheenvironment.