Renkforce RF100 v2 - Preparation Steps; Build Bed Calibration Guide

21
14. Preparation
a) Calibrate build bed
1
2
3
• Pressthecontrolknobin<Info
screen>toenter<MainPage>.
• In < Main > menu select
< Prepare > .
• Select<Autohome>.
4
Prepare
First point
Second point
Third point
5
6
• Adjust 3 screws under build bed
toadjust thegapbetween build
bed and nozzle until built plate is
lyingat.
• Gapdistanceshouldbebetween
0.1 and 0.3 mm (i.e. use A4
paper as a measurement tool).
Nozzle must not touch build
plate!
• Returnto<Prepare>menu.
• Enter < Level bed > menu and
select < First point >.
• Ensure during build bed
adjustment, that the distance
between nozzle and build bed
should be same each time.
Otherwise build bed is uneven
andprintobjectsmaynotadhere
to it properly.
• Repeat STEPS 1-4 for second
and third points (calibration
sequenceandmovementpathof
nozzleareshown).