Renkforce RF100 v2 - Unloading Filament; Storing the 3 D Printer

43
f) Unload lament
• Ensurethenozzletemperaturereaches170°Corabove.
Auto home
Level Bed
Preheat PLA
Main
1
Unload filament
Move axis
Disable steppers
Temperature
2
• Select<PreheatPLA>.
• Select<Unloadlament>.
• Removelamentspoolfromthe
lamentspoolholder.
Ifthelamentmaterialiseitherwoodormetal,cutitandreplaceitwithPLAlamentrstasdescribedin
section“d) Change / Replace lament“ on page 24, then unload the PLA lament. The PLA lament
removespossibleresidueleftbehindbythewoodormetallament.
g) Store the 3D printer
• Unloadthelament.
• MovethepowerswitchintotheoffpositionOanddisconnecttheprinterfromthemainsvoltage.Lettheprintercool
down to room temperature.
• Cleantheprinterifyouarenotgoingtouseitforanextendedperiodoftime.
• Storeitinadry,dust-freelocationoutofthereachofchildren.