Renkforce RF100 v2 - Page 14

14
2
• Usetwoscrewsandthehexkeytoinstall
lamentspoolholderatthebackofthe3D
printer.
The ‘nose’ at the end of the holder faces
upwards.
• Placethebuildbed.
1
4
• Connectthepowercablewiththepowersupply
socket.
• Fullyunwindthepowercableandinsertthemains
plugintoawall-mountedsocket.
• InsertSDcardwithstickerfacingdownwards.
3
• Switchthe3Dprinteronbymovingthepower
switchtotheI position.
• Theprintingareaislitup.
• < Info screen > appears on the LCD display. It
indicatesthatthe3Dprinterisnowreadytouse.
5