Renkforce RF100 v2 - Page 16

16
Menu option Function
<PreheatPLA>
Conrmthismenuoptionandthenozzlestartsheatinguptothedefaulttemperature
of 220°C.
Ifthereisnoactionduringthefollowing5minutes,heatingwillbeturnedoff
and the nozzle will be cooled down to prevent lament overheating and
blockageofnozzle.
<Loadlament>
Selectthisfunctiontoloadlamentintotheextruder.
The3Dprinterwilldraw80mmoflamentintotheextruder.
Nozzletemperaturemustbehigherthan170°C.
<Unloadlament>
Selectthisfunctiontounloadlamentfromextruder.
The3Dprinterwilldraw10mmoflamentintotheextruder,afterwards80mmoutof
theextruder.
Nozzletemperaturemustbehigherthan170°C.
< Move axis > Enterthe<Moveaxis>menu.
< Disable steppers > Switchoffallmotors.ExtruderandbuildbedcanbemovedalongX,Y,Zaxisbyhand.
< Temperature > Enterthe< Temperature > menu.
< SD card > menu Fordetails,refertochapter“5.SDcardcontent“onpage6.
< Level bed > menu
< Prepare > Returnto< Prepare > menu.
< First point > Adjustrstpointforbuildbedcalibration.Extrudergoestorstcalibrationpoint.
< Second point > Adjustsecondpointforbuildbedcalibration.Extrudergoestosecondcalibrationpoint.
<Thirdpoint> Adjustthirdpointforbuildbedcalibration.Extrudergoestothirdcalibrationpoint.
< Move axis > menu
< Prepare > Returnto< Prepare > menu.
< Move 10mm >
Adjusttheknobsensivity:10mmmovementper1increment.
Enterthe<Move>menutoselecttheX-andY-axismovement.
< Move 1mm >
Adjusttheknobsensivity:1mmmovementper1increment.
Enterthe<Move>menutoselecttheX-,Y-andZ-axismovement.
< Move 0.1mm >
Adjusttheknobsensivity:0.1mmmovementper1increment.
Enterthe<Move>menutoselecttheX-,Y-andZ-axismovement.
< Move > menu
< Move axis > Returnto<Moveaxis>menu
< MoveX>
SelectX-Axismovementandenterthe< MoveX>menutoadjusttheX-axismovement
intherange0to+120mm.
Theextrudermovestoleft/rightalongtheX-axis.