Reolink C1 User Manual

35
 Enable auto reboot: Enable or disable auto reboot of the camera.
 Auto reboot at: Choose when you’d like the camera to reboot.
 Default Settings: Click Restore to reset the camera to factory default.
 Configuration: Export or import the configuration file including all the settings done
to the camera.
 Firmware Upgrade: Instructs the Camera to update its firmware.
How to upgrade firmware:
1. Download the firmware from Reolink official website: https://reolink.com/firmware/
2. Go to Device Settings > System > Maintenance, click on From Local.
3. Click on Browse to locate the upgrading file (end with pak), click on Upgrade to upgrade
the firmware.
Note: It is suggested to check Update Configure File when upgrading the firmware.
And the configuration set to the camera will be erased, you will need to configure the
camera again.

Reolink C1 Specifications

General

Frame Rate	20fps
Image Sensor	1/2.7" CMOS
Wireless Standard	IEEE 802.11b/g/n
Operating Frequency	2.4GHz
Wireless Security	WPA/WPA2
Protocols	HTTPS, SSL, TCP/IP, UDP, HTTP, IPv4, UPnP, RTSP, RTMP, SMTP, NTP, DHCP, DNS, DDNS, FTP, P2P
Storage	Micro SD card (up to 128GB)
Operating Temperature	-10° C~+55° C (14° F~131° F)