© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197
| support@rgblink.com | www.rgblink.com
Chapter 5 XPOSE mini Operation
XPOSE mini is a software that allows you to control your mini-pro, RGBlink is available for all
platforms including Android, iOS, MacOS, Windows.
Minimum System Requirements for macOS
Windows：
● CPU:i5 and above
● Memory:8 GB or more
● Operating System: Windows 10 64 bit processor or above
● Graphics: Support Direct X9 128M or above (open AERO effect)
● Hard disk space: Above 16G (primary partitions, NTFS format)
● Connector: USB 3.0 or type c
● Others: do not run multiple video capture or editing software simultaneously
MAC：
●
CPU：i5 and above
● Connector: USB 3.0 or type c
● Operating System: macOS 11.0 Big Sur or later
macOS 10.15 Catalina
● Others: do not run multiple video capture or editing software simultaneously
You can either connect the mini-pro directly to your computer via the LAN port provided by the
mini-pro, or link the mini-pro to your router and the computer to the Wi-Fi emitted by your wireless
router.
5.1 Connect mini-pro and computer
Direct Link via a Network Cable
(1)Modify mini-pro’s IP Address
The mini-pro is connected to a computer via TCP/IP protocol for data transfer. Therefore, you need
to keep the mini-pro on the same IP network segment as your PC or mobile device. If the mini-pro is
connected directly to a computer, you need to change the mini-pro's IP manually to avoid IP
conflicts on the same network segment.
Steps to modify mini-pro’s IP address:
1. Push【M】button,enter【Settings】--【IP Setting】menu;
Note:The IP address of the mini-pro must be in the same WLAN segment as the computer or the mobile
control device you choose.
To Next Page
Loading...
Need help?
General
