© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 592 5771197
| support@rgblink.com | www.rgblink.com
Step 5. Choose Properties after right clicking on the network name.
Step 6. Select the Internet Protocol Version 4 (TCP/IPv4), then click Properties.
Step 7. Obtain an IP Address automatically should be selected by default, but please choose the Use the
Following IP Address.
Step 8. Now put your desired IP Address according to your wish its correct format. Change Subnet mask
and default gateway if you want to.
Install XTOOL App
Step 1. Extract the Firmware ZIP package into a folder
Step 2. Navigate to the /Upgrade Tool/XTOOL folder
Step 3. Right mouse-click the XTOOL Soft Setup and Run as Administrator [Windows]
Step 3. Follow the Setup Wizard to install all the components. There will be multiple Dialog windows pop-up for
installing the necessary components (refer XTOOL Installation Guide)
If the XTOOL app has been installed previously, use the Modify option to complete the setup.
XTOOL is a universal updater application for RGBlink products, as such has a number of features in support of
the full range of RGBlink devices that are not utilized for mini-pro updates in this guide.
Open the XTOOL app with Run as Administrator [Windows]
1. Click”Connection”and select “mini series”
2. Fill in the IP Address of the mini-pro(as
example above, default mini-pro IP is
192.168.0.99),and click “Confirm”.
3. Review Connection Status at bottom left, to
confirm indicator light is green and there is
device information showing at bottom right.
4. The firmware package will be ready with
XTOOL automatically.
To Next Page
Loading...
Need help?
General
