31
Section I :: User
If you enabled band operation the following screens allow you to set the
hours and periods of operation:
In the next dialog you can set the automatic switch between Standard
Time and Daylight Saving Time.
Once the function has been enabled, specify the dates and times of the
time switch. Pre-settings are:
o last Sunday of March at 2.00 am;
o last Sunday of October at 03:00 am;
1. Date to be programmed. If “---“ then the daily time periods are
disabled
2. The current day setting can be copied on another day at will
3. Setting the starting time of the time period. This ends with the
beginning of the subsequent time period.
4. Settings used when the unit is in cooling mode
5. Settings used when the unit is in heating mode
6. Starting date of special period
7. End date of special period
8. Settings used when the unit is in cooling mode
9. Settings used when the unit is in heating mode
10. Special day
11. Settings used when the unit is in cooling mode
12. Settings used when the unit is in heating mode
The software forces the insertion of the times in an increasing manner.
If “---“ then the time period is disabled
Example:
Time period 1 begins at 8:30 and ends at 22:00
Time period 2 begins at 22:00 and ends at 23:00
Time period 3 begins at 23:00 and ends at 8:30
To Next Page
Loading...
Need help?
General