23
13. For safety using, load detection was
designed in this device after the output
intensity surpass 10.0mA/10.0V. If there are
no electrodes stuck on patients’ skin, an alarm
buzzer sound will appear and the intensity
value will flash .
14. Press the [STOP] button to stop treatment
of the current channel(s). If you want to
stop the other channel(s) treatment, press
corresponding channel button first, and then
press the [STOP] button.
CAUTION: This will only stop the selected
flashing channels, not both channels.
15. To pause a channel, press the
corresponding channel knob on the top of the
device and then press the central controller
dial to pause that channel. Each channel must
be paused individually.
STOP
To Next Page
Loading...
