Loading Paper
19
1
Specifying custom size paper for the
optional paper feed unit
Important
❒ When printing on custom size pa-
per, specify the paper size using
the control panel or printer driver.
❒ The custom size paper selected us-
ing the printer driver overrides
that selected using the control pan-
el. Do not make settings using the
control panel if you have already
made settings using the printer
driver. However, when printing
with a printer driver other than the
RPCS printer driver, you must
configure the settings using con-
trol panel.
❒ The following is the range of paper
sizes that can be loaded in each
type of the paper trays:
• Optional paper feed unit (Tray
2, Tray 3): 182 - 297 mm in width
and 60 - 432 mm
❒ The printer cannot print from ap-
plications that do not support cus-
tom size paper.
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Paper Input], and then press
the {# Enter} key.
The paper selection menu appears.
C Press the {U} or {T} key to dis-
play [Tray Paper Size], and then
press the {# Enter} key.
The paper tray selection menu ap-
pears.
D Press the {U} or {T} key to dis-
play the target paper tray, and
then press the {# Enter} key.
The paper size selection menu ap-
pears.
E Press the {U} or {T} key to dis-
play [Custom Size], and then press
the {# Enter} key.
F Press the {U} or {T} key to set
horizontal value, and then press
the {# Enter} key.
Press the {T} or {U} key scrolls
the value in increments of 0.1 mm.
Pressing the {T} or {U} key scrolls
the value in increments of 1 mm.
The screen for entering the length
appears.
AGN200S
Menu:
Paper Input
Tray Paper Size:
Tray 2
Custom Size:
Horiz. 210.0 mm
KirP4GB_Mainte-F5_FM_forPaper.book Page 19 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
