Error & Status Messages on the Control Panel
57
5
Hardware Problem
Option RAM
The printer identified an op-
tional RAM error.
Turn the power off, and then on. Re-
move and re-install the optional
RAM. If the message appears again,
contact your sales or service repre-
sentative.
See “Attaching Memory Unit Type C
256MB (SDRAM Module)”, Setup
Guide.
Turn off the power, remove the mem-
ory unit, and then turn on the power.
Note
❒ If you remove the memory unit,
you must set up the option with
the printer driver.
❒ In this case, you might not be able
to print complex print jobs.
Hardware Problem
Parallel I/F
There is a problem with the
parallel interface.
If you use the parallel I/F, replace the
interface cable that caused the error. If
the message appears again, contact
your sales or service representative.
Hardware Problem
USB
There is a problem related to
the Universal Serial Bus Con-
nection and Hardware.
Turn the power off, and then on. If the
message appears again, contact your
sales or service representative.
Hardware Problem
Wireless Board
An error was detected in the
IEEE 802.11b interface unit or
the Bluetooth interface unit.
Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b
interface unit or the Bluetooth inter-
face unit correctly.
If the message appears again, contact
your sales or service representative.
See “ Attaching 802.11b Interface Unit
Type F ” or “Attaching Bluetooth In-
terface Unit Type C ”, Setup Guide.
Hardware Problem
Wireless Card
The IEEE 802.11b interface unit
or the Bluetooth interface unit
could not be detected when the
power was turned on. The IEEE
802.11b interface card or the
Bluetooth interface card was
removed after the power was
turned on. An error was detect-
ed in the IEEE 802.11b interface
card or the Bluetooth interface
card.
Turn the power off, and then on. Re-
move and re-install the IEEE 802.11b
interface unit or the Bluetooth inter-
face unit correctly.
If the message appears again, contact
your sales or service representative.
See “ Attaching 802.11b Interface Unit
Type F ” or “Attaching Bluetooth In-
terface Unit Type C ”, Setup Guide.
Messages
/Second messages
Description Solution
KirP4GB_Mainte-F5_FM_forPaper.book Page 57 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
