Making Printer Settings Using the Control Panel
147
❒ Default: Driver/Command
❒ Appear only at network standard model.
❖ RAM Disk
If the optional hard disk is not installed for PDF Direct Print, select a value of
2 MB or higher.
This menu appears only when the optional hard disk is not installed.
• 0 MB
• 2 MB
• 4 MB
• 8 MB
•16 MB
❒ Default: 4 MB
❒ When the amount of SDRAM is small and RAM Disk is set to 16 MB, print-
ing may not be possible depending on the print job and duplex printing may
be canceled. If this happens, increase the amount of SDRAM, or set RAM
Disk to 8 MB or less.
For details about the optional SDRAM module, see Setup Guide.
❖ Notify by Email
You can specify whether or not to send an error message to a preset e-mail
address when an error occurs in the printer.
•Off
•On
❒ After changing the setting, turn off the power of the printer briefly, and then
turn it on again.
❒ Default: On
For information, see Web Image Monitor Help.
❖ Email Date
When a mail date/time cannot be notified, the user can set whether a dummy
date/time is set or not.
•Off
To Next Page
Loading...
