Installing Options
40
3
B
Turn off the power of the printer,
and then unplug the printer's pow-
er cable and the interface cable.
C If the duplex unit is attached,
push down the lever on right side
( ) and pull out the duplex Unit
until it stops ( ).
If the duplex unit is not attached,
go to the following steps.
D Remove the two screws holding
the controller board in place.
Note
❒ Use a coin or similar object if the
screws do not turn easily.
❒ These screws are used again in
fastening the controller board.
E Pull out the handle of the control-
ler board.
F Pull the handle, and then slide
the controller board out.
G Place the controller board on a flat
surface.
H Remove the two screws and the
cover of the 1394 interface unit
mounting bracket.
Note
❒ These screws are used again in
fastening the 1394 interface unit
to the controller board.
ZKGX320E
ZKGX280E
ZKGX370E
ZKGX260E
KirP4GB_Setup-F4_FM_forPaper.book Page 40 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
