6. Depending on the destination setting, enter the user name for logging on to the client
computer.
Press [Manual Entry] to the right of the user name field to display the soft keyboard.
7. Depending on the destination setting, enter the password for logging on to the client
computer.
Press [Manual Entry] for the password to display the soft keyboard.
8. Press [Connection Test].
A connection test is performed to check whether the specified shared folder exists.
9. Check the connection test result, and then press [Exit].
10. Press [OK].
• If authentication is required to access the folder, the login screen appears. Enter the user name
and password.
• If you change the protocol after entering the path name, user name, or password, a confirmation
message appears.
• Computer and shared folder names containing more than 12 characters cannot be displayed.
• To change the path for the folder that has been entered, press [Edit] on the left side of the
destination field. Enter the correct path for the folder, and then press [OK].
• The connection test may take time.
• You may not be able to press [Connection Test] right after pressing [Cancel] during a connection
test.
• Even if the connection test was successful, the machine may fail to transfer the file if you do not
have write privileges for the file or there is not enough free hard disk space.
• You can register the path to the destination in the machine's address book. For details, see
"Registering the Path to the Selected Destination in the Address Book".
• If the message "Cannot find the specified path. Please check the settings." appears, see
"Troubleshooting When Using the Scanner Function", Troubleshooting.
• p.75 "Registering the Path to the Selected Destination in the Address Book"
Specifying the path by browsing the network for destinations
You can browse computers on the network for the destination folder, and then specify the path.
2. Sending Scan Files to Folders
68
To Next Page
Loading...
Need help?
General
