• p.152 "Setting procedure of a custom size when scanning part of an original"
Setting procedure of a custom size when scanning part of an original
This section explains how to specify a custom size for scanning part of an original.
To scan part of an original, measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area
(X3 and Y3) on the surface of the original, and then enter those values in the same order on the custom
size setting screen.
To display the custom size setting screen, on the initial scanner screen, press [Scan Settings] > [Scan Size]
> [Custom Size].
Measuring methods differ depending on where the original is placed and the orientation it is placed in.
For details about how to measure Original Size (X1 and Y1), Start Position (X2 and Y2), and Scan Area
(X3 and Y3) correctly, see "How to measure sizes".
Enter the sizes while referring to "Scan settings on the custom size setting screen".
How to measure sizes
Orientation and placement of original Measuring method for scanning the "R" section
In the orientation on the exposure
glass or in the ADF.
To Next Page
Loading...
Need help?
General
