access
Use the “access” command to view and configure access control. You can also specify two or more access
ranges.
View settings
msh> access
IPv4 configration display
msh> access ID range
IPv6 configuration display
msh> access ID range6
IPv6 access mask configuration display
msh> access ID mask6
IPv4 configuration
msh> access ID range “start-address end-address”
Example: to specify accessible IPv4 addresses between 192.168.0.10 and 192.168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20
IPv6 configuration
msh> access ID range6 “start-address end-address”
Example: to specify accessible IPv6 addresses between 2001:DB8::100 and 2001:DB8::200.
msh> access 1 range6 2001:DB8::100 2001:DB8::200
IPv6 access mask configuration
msh> access ID mask6 “base-address prefixlen”
Example: to specify accessible IPv6 addresses to 2001:DB8::/32
msh> access 1 mask6 2001:DB8:: 32
Access control initialization
msh> access flush
• Use the “flush” command to restore the default settings so that all access ranges become
“0.0.0.0” for IPv4, and “::” for IPv6.
• You can specify each IPv6 entry by either range or mask. For the range parameter, you can select
“start-address end-address”. For the mask parameter, you can select “baseaddress prefixlen”.
• The access range restricts computers from use of the machine by IP address. If you do not need to
restrict printing, make the setting “0.0.0.0” for IPv4, and “::” for IPv6.
• Valid ranges must be from lower (start address) to higher (end address).
Remote Maintenance by telnet
165
To Next Page
Loading...
Need help?
General
