The default setting is [Auto-Obtain (DHCP)].
When you select [Specify], enter the DNS Server IPv4 address as "xxx.xxx.xxx.xxx" ("x" indicates a
number).
DDNS Configuration
Specify the DDNS settings.
The default setting is [Active].
IPsec
Specify the machine's IPsec function Active/Inactive.
The default setting is [Inactive].
Domain Name
Specify the domain name.
The default setting is [Auto-Obtain (DHCP)].
When you select [Specify], enter the domain name using up to 63 characters.
WINS Configuration
Specify the WINS server settings.
The default setting is [On].
If [On] is selected, enter the WINS Server IPv4 address as "xxx.xxx.xxx.xxx" ("x" indicates a number).
If DHCP is in use, specify the "Scope ID". Enter a "Scope ID" using up to 31 characters.
Effective Protocol
Select the Protocol to use in the network.
The default setting for "IPv4" is [Active].
The default setting for "IPv6" is [Inactive].
The default setting for "NetWare" is [Inactive].
The default setting for "SMB" is [Active].
The default setting for "AppleTalk" is [Active].
NCP Delivery Protocol
Select the protocol NCP delivery.
The default setting is [TCP / IP Priority].
If you select [IPX Only] or [TCP / IP Only], you cannot switch the protocol even if you cannot connect
with it. If "NetWare" in "Effective Protocol" is set to [Inactive], you can only use TCP/IP.
NW Frame Type
Select the frame type when you use NetWare.
The default setting is [Auto Select].
1. System Settings
34
To Next Page
Loading...
Need help?
General
