You can search by the registered name, fax number, folder name, e-mail address, or IP-Fax
destination.
7. Press [Folder].
8. Select "Connection Type".
If you want to specify a folder in an NDS tree, press [NDS]. If you want to specify a folder on a
NetWare server, press [Bindery].
9. Specify the folder.
To specify a folder, you can either enter the path manually or locate the folder by browsing the
network.
10. Press [Connection Test] to check the path is set correctly.
11. Press [Exit].
12. Press [OK].
13. Press [Exit].
14. Press the [User Tools/Counter] key.
• To change the name, key display and title, see "Registering Names".
• p.245 "Registering Names"
Changing the protocol
This section describes how to change the protocol.
1. Press [SMB] or [FTP].
2. A confirmation message appears. Press [Yes].
Changing the protocol will clear all settings made under the previous protocol.
3. Enter each item again.
Registering Folders
291
To Next Page
Loading...
Need help?
General
