Registering Addresses and Users for Scanner Functions
146
6
I Enter the login user name, and then press [OK].
J Press [Change] under "Login Password".
K Enter the password, and then press [OK].
L Enter the password again to confirm, and then press [OK].
M Press [Folder].
N Press [FTP].
O Press [Change] under "Server Name".
P Enter the server name, and then press [OK].
Q Press [Change] under "Path".
R Enter the path, and then press [OK].
You can enter an absolute path, using this format: “/user/ home/username";
or a relative path, using this format: “directory/sub-directory".
If you leave the path blank, the login directory is assumed to be the current
working directory.
You can also enter an IPv4 address.
You can enter a path using up to 256 characters.
S To change the port number, press [Change] under "Port No".
T Enter the port number using the number keys, and then press the {q} key.
You can enter 1 to 65535.
U Press [Connection Test] to check the path is set correctly.
V Press [Exit].
If the connection test fails, check the settings, and then try again.
W Press [OK].
X Press [Exit].
To Next Page
Loading...
