Preventing Unauthorized Access
133
5
Access Control
This can be specified by the network administrator.
The machine can control TCP/IP access.
Limit the IP addresses from which access is possible by specifying the access
control range.
For example, if you specify the access control range as [192.168.15.16]-
[192.168.15.20], the client PC addresses from which access is possible will be from
192.168.15.16 to 192.168.15.20.
Limitation
❒ Using access control, you can limit access involving LPR, RCP/RSH, FTP,
IPP, DIPRINT, Web Image Monitor, SmartDeviceMonitor for Client or Desk-
TopBinder. You cannot limit the Monitoring of SmartDeviceMonitor for Cli-
ent.
❒ You cannot limit access involving telnet, or monitoring SmartDeviceMonitor
for Admin.
A Open a Web browser.
B Enter "http://(machine's-address)/" in the address bar to access the machine.
C Click [Login].
The network administrator can log on using the appropriate login user name
and login password.
D Click [Configuration], under [Security], click [Access Control].
The [Access Control] page appears.
E To specify the IPv4 Address, in [Access Control Range], enter an IP address
that has access to the machine. To specify the IPv6 Address, in [Access Con-
trol Range] - [Range], enter an IP address that has access to the machine, or in
[Mask], enter an IP address from which access to the machine and specify
the [Mask Length].
F Click [OK].
Access control is set.
G Click [Logout].
Reference
For details, see the Web Image Monitor Help.
To Next Page
Loading...
