Appendix
46
3
❒ Depending on the ambient temperature and humidity, steam may come from
the exhaust vent behind the control panel during printing. This is water va-
pour from the paper, not a sign of malfunction.
❒ Do not open the main unit cover, the paper roll tray, or the cut paper tray
when the machine is in operation. If you do, misfeeds might occur.
❒ Do not leave the main unit open for more than 10 minutes, otherwise image
quality may deteriorate.
❒ If you do not use the machine for a long time, remove the paper from the pa-
per roll tray, or the cut paper tray and place it in its storage bag.
❒ Condensation can lead to image deterioration. To prevent this, this machine
has an anti-condensation function. Even when the main power switch is in
the standby position, the anti-condensation heater is active, keeping the ma-
chine body slightly warm.
❒ The paper roll tray has the anti-humidity function. Even when the main pow-
er switch is in the standby position, the anti-humidity heater is active if it is
turned on.
❒ Be sure to make a note of the registered machine settings in case they are lost
due to accident or malfunction.
❒ The supplier shall not be liable for any loss or damage resulting from a failure
of the machine, loss of settings, or use of the machine.
Reference
p.36 “Turning Off the Power”
p.37 “Turning Off the Main Power”
p.39 “Anti-humidity Heater Switch”
To Next Page
Loading...
