Ricoh B064 - Page 479

SERVICE PROGRAM MODE TABLES
SM 5-77 B064 Series/B140 Series/G126
Service
Tables
5816* Remote Service (B064 only)
001
I/F Setting
Turns the remote diagnostics off and on.
[0~2/1]
0: Remote diagnostics off.
1: Serial (CSS or NRS) remote diagnostics on.
2: Network remote diagnostics.
002 CE Call
Lets the customer engineer start or end the remote machine
check with CSS or NRS; to do this, push the center report
key.
003 Function Flag
Enables and disables remote diagnosis over the NRS
network.
[0~1/1]
0: Disables remote diagnosis over the network.
1: Enables remote diagnosis over the network.
004
Communication
Test Call
Push “Execute” to do a transmission test call for NRS. The
test gives a value from 0 to 99.
[0~1/1]
0: Normal end (center operates)
1: Normal end (center does not operate)
Other: Not normal
005
Device
Information Call
Push “Execute” to test if the machine operates.
[0~1/1]
0: Normal end (center operates)
1: Normal end (center does not operate)
Other: Not normal
006
Device
Information Call
Display
Controls if the item for initial setting of the screen for the NRS
device-information notification-call is shown.
[0~1/1]
0: Enabled. Item initial setting not shown.
1: Disable. Item for initial setting shown.
007 SSL Disable
Controls if RCG (Remote Communication Gate) confirmation
is done by SSL during an RCG send for the NRS over a
network interface.
[0~1/1]
0: Yes. SSL not used.
1: No. SSL used.
008
RCG Connect
Timeout
Sets the length of time (seconds) for the time-out when the
RCG (Remote Communication Gate) connects during a call
via the NRS network.
[1~90/1 sec.]
009
RCG Write to
Timeout
Sets the length of time (seconds) for the time-out when sent
data is written to the RCG during a call over the NRS
network.
[0~100/1 sec.]
010
RCG Read
Timeout
Sets the length of time (seconds) for the timeout when sent
data is written from the RCG during a call over the NRS
network.
[0~100/1 sec.]