Paper Delivery
C274 4-44 SM
2. Loosen screw [B] then screw [C] in that order (do not remove them). Make sure that
the bracket [D] becomes free from engagement and the cam follower [E] contacts the
drum flange.
3. Measure the gap [F] between the cam follower and cam face (front drum flange). It
should be 0 to 0.5 mm.
4. If the gap is not correct, loosen the two screws securing the cam follower bracket [G].
5. Re-tighten the two screws while pushing the cam follower against the cam face. Make
sure that the gap [F] is 0 or less than 0.5 mm.
Do not push the cam followers too strongly against the cam.
6. Re-position the bracket [D] and tighten the screws [B] and [C].
To Next Page
Loading...
