Master Feed
C274 4-18 SM
[C]: Thermal head side cover ( x 1)
Close the platen roller unit.
[D]: Thermal head ( x 2)
Installation
If the following remarks are not followed, the thermal head will be installed incorrectly.
1. Fit the base’s springs [A] over the protrusions [B] on the underside of the thermal head
(5 points).
2. While fitting the tops of the springs [A] over the protrusions on the underside of the
thermal head, hook the lock pawls [C] of the thermal head onto the base (3 lock pawls).
Make sure to set the front side (the paper table side) first.
3. Make sure that all protrusions are properly fitted into the springs.
Adjust the thermal head voltage after installing the new thermal head. (
Thermal Head Voltage Adjustment)
To Next Page
Loading...
