Drum
C274 4-34 SM
4.9.3 CLAMPER / METAL SCREEN
Remove the drum
Cloth screen ( Cloth Screen)
[A]: Clamper lever (1 hexagon screw)
[B]: Clamper - open the clamping plate [C], then remove the clamper.
Do not allow ink to get on the inside of the clamping plate [C]. Otherwise, the
master may slip off and the image position on the prints will move toward the
trailing edge of the prints during a printing run.
Use a cloth dampened with water to clean the inside of the clamping plate [C].
Never use alcohol or other solvents, or the clamping force of the magnet will be
weakened.
[D]: Tape (do not lose it)
[E]: Metal screen ( x 12)
To Next Page
Loading...
