Drum
SM 4-35 C274
Replacement
and
Adjustment
Installation
Make sure that the correct end of the metal screen is overlapping. (The right side
overlaps, as viewed from the non-operation side, as shown above.)
Secure the metal screen with filament tape.
The 4 screws holding the drum master clamper are longer than the 12 screws holding
the metal screen, although they are similar in appearance. Be careful not to mix them
up or use the wrong screws.
When installing the metal screen, secure the trailing edge first with the 2 screws. Then,
tighten the other screws while removing the slack from the screen. Make sure that the
gap between the drum flanges and the screen is 0.3 mm or less, as shown above.
(The two holes [A] on the trailing side are round holes and the other holes are long
To Next Page
Loading...
