Ricoh C274

SC Tables
C274 3-2 SM Appendix
No. Symptom Possible cause
E-12
Pressure Plate error
The pressure plate home position sensor signal is not
detected within 3.0 seconds after the pressure plate
motor turns on.
Pressure plate drive
Pressure plate motor
Plate position sensors
E-14
IPU error
Signal transmission error (from the IPU) occurred in
the MPU
MPU
E-23
Master Eject Position Sensor (Drum HP) error
The master eject position sensor does not activate
before the feed start timing sensor activates.
Master eject position
sensor
Feed start timing sensor
Feeler
E-24
Feed Start Timing Sensor error
The feed start timing sensor does not activate before
the master eject sensor activates.
Master eject position
sensor
Feed start timing sensor
Feeler
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA