and other devices. To prevent electrical shock, switch the machine off, wait for
a few seconds, then unplug the machine from the power source.
Before you do any checks or adjustments after turning the machine off, work
carefully to avoid injury. After removing covers or opening the machine to do
checks or adjustments, never touch electrical components or moving parts
(gears, timing belts, etc.).
After turning the machine on with any cover removed, keep your hands away
from electrical components and moving parts. Never touch the cover of the
fusing unit, gears, timing belts, etc.
Installation, Disassembly, and Adjustments
After installation, maintenance, or adjustment, always check the operation of
the machine to make sure that it is operating normally. This ensures that all
shipping materials, protective materials, wires and tags, metal brackets, etc.,
removed for installation, have been removed and that no tools remain inside
the machine. This also ensures that all release interlock switches have been
restored to normal operation.
Never use your fingers to check moving parts causing spurious noise. Never
use your fingers to lubricate moving parts while the machine is operating.
Special Tools
Use only standard tools approved for machine maintenance.
For special adjustments, use only the special tools and lubricants described in
the service manual. Using tools incorrectly, or using tools that could damage
parts, could damage the machine or cause injuries.
During Maintenance
General
Before you begin a maintenance procedure: 1) Switch the machine off, 2)
Disconnect the power plug from the power source.
Safety Devices
Never remove any safety device unless it requires replacement. Always
replace safety devices immediately.
Never do any procedure that defeats the function of any safety device.
To Next Page
Loading...
