9. Scanner Features
Accessing User Tools
This section describes how to change the settings of [Scanner Features].
• Procedures for configuring system settings differ from procedures for configuring other settings. You
must return to the initial screen when you finish configuring the system settings. For details about
returning to the initial screen, see "Closing User Tools".
• Any changes you make in [Scanner Features] remain in effect even if the main power switch or
operation switch is turned off, or the [Energy Saver] or [Clear Modes] key is pressed.
• Depending on the sending method, some settings cannot be applied.
• p.182 "Closing User Tools"
Changing User Tools
This section describes how to change the settings of [Scanner Features].
• If Administrator Authentication Management is specified, contact your administrator.
1. Press the [User Tools/Counter] key.
2. Press [Scanner Features].
3. Select the item you want to change.
4. Change settings by following instructions on the display, and then press [OK].
181
To Next Page
Loading...
Need help?
General
