• For IPv4 and IPv6, you can select an ID number between 1 and 5.
• IPv6 can register and select the range and the mask for each access ranges.
• IPv6 mask ranges between 1 - 128 can be selected.
• Up to five access ranges can be specified. The entry is invalid if the target number is omitted.
• You cannot send print jobs, or access Web Image Monitor and diprint from a restricted IP address.
appletalk
Use the “appletalk” command to view and configure AppleTalk parameters.
View settings
msh> appletalk
• [2] means “active” and [0] means “inactive”.
• The default is [2].
Changing PAP timeout configuration
msh> appletalk ptimeout value > 0
• Timeout value becomes effective.
msh> appletalk ptimeout value = 0
• Timeout value becomes ineffective.
authfree
Use the "authfree" command to view and configure AuthFree parameters.
View settings
The following command displays the current AuthFree settings:
msh> authfree
• If print job authentication exclusion is not set, authentication exclusion control cannot be
displayed.
IPv4 address settings
msh> authfree "ID" range_addr1 range_addr2
IPv6 address settings
msh> authfree "ID" range6_addr1 range6_addr2
IPv6 address mask configuration
msh> authfree "ID" mask6_addr1 masklen
4. Monitoring and Configuring the Printer
166
To Next Page
Loading...
Need help?
General
