2. General Operations For Servicing
Start-Up, Shut-Down, and Reboot
The copier and the E-24B have separate main power switches. During normal operation, you can leave
the E-24B main power switch in the ON (I) position.
Starting the Copier and the E-24B
1. Turn ON the main power switch of the copier.
2. If the main power switch of the E-24B is OFF (O), turn ON the main power switch of the
E-24B.
3. Press and release the soft power push button on the front of the E-24B. The controller
enters into the boot-up sequence.
4. After the E-24B and the copier become idle, press the Home button on the operation
panel of the copier and then touch the Fiery icon. The Fiery menu screen will appear on
the copier operation panel.
Shutting Down the Copier and the E-24B
1. Make sure that the E-24B is not receiving, processing, or printing any jobs.
If "Printing" appears on the operation panel, the E-24B is processing. You must wait until the system
finishes and reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches Idle
before beginning the shutdown procedure.
2. Press the Home button on the operation panel of the copier and then touch the Fiery icon.
The fiery menu screen appears.
3. Move to the Fiery tab.
59
To Next Page
Loading...
